AV-1434EE
AV-1414EE
Measuring
ItemTest pointAdjustment partDescription
instrument
AdjustmentSignal4. VER. LIN.IIII When the vertical linearity has been deteriorated
generator
of VER. LIN.5. VER. SCURVEremarkably, perform the following steps.
& VER.13. Input a cross-hatch signal.
Remote
SCURVEcontrol unit14. Select 4. VER. LIN. with the MENU 1/2 key.
15. Set the initial setting value of 4. VER LIN. with the MENU - / +
key.
16. Select 5. VER. SCURVE with the MENU 1/2 key.
17. Set the initial setting value of 5. VER. SCURVE with the
MENU - / + key.
18. Adjust 4. VER. LIN. and 5. VER. SCURVE so that the spaces
of each line as shown in Fig.3 on TOP, CENTER and
BOTTOM become uniform.
Make sure that the adjustment is properly done on the screen of
TOP
60Hz mode.
[NOTE]
" Adjust to make both 50Hz & 60Hz are the same v. size and
CENTERfine straight line.
" When adjust again, adjust 50Hz mode first.
" When adjust in 60Hz mode, only 60Hz mode is adjust.
BOTTOM
Fig.3
30No. 52015 |